Diagnostic Trouble Code (DTC) Information

ECM-9300 CLUTCH PEDAL POSITION SENSOR, FAULTY SIGNAL
DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION




Condition
Diagnostic Trouble Code (DTC) ECM-9300 is stored if the Engine Control Module (ECM) registers a fault in the signal from clutch pedal position sensor.

Condition
Cruise control shut off.

Possible source

Signal too high:
- short-circuit to ground in the signal cable
- defective clutch pedal sensor.

Signal too low:
- short-circuit to ground in the signal cable
- defective clutch pedal sensor.

Faulty signal:
- incorrectly installed clutch pedal sensor
- defective clutch pedal sensor.

Condition
- Electronic throttle system warning lamp lights
- cruise control does not function at all.