Signal Too High - Intermittent Fault

ECM-2A2A REAR HEATED OXYGEN SENSOR (HO2S) PREHEATING
SIGNAL TOO HIGH - INTERMITTENT FAULT

Checking cables



Check signal cable between Heated Oxygen Sensor (HO2S) # 2 and control module # A35 (# A35) for an intermittent short-circuit to supply voltage according to [1][2]Checking Wiring and Terminals. Intermittent Faults

Other information
- Connecting the breakout box/accessing the control module Connecting the Breakout Box (ECM)
- To access/replace the heated oxygen sensor (HO2S), Adapter Wiring Switch, Replacing
- For information about signals, see Diagnostic Parameters and Pinout Values. Signal Description, ME7, B5XX4T


Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.