Programming Driver Position (LHD or RHD)

Programming Driver Position (LHD Or RHD)







NOTE: In order for a new ECC control module to function, the control module must be programmed for the driver position (LHD or RHD). A control module that has not been programmed will not operate at all and the green indicator LEDs in the REC and AC buttons will flash. After programming with the driver position, the green LED in the A/C button will flash and continue to do so until the self-adjustment of the damper motor is complete.


- Ignition on
- Use the Programming function to read out and program the ECC Control module. Programmable data is: left-hand drive or right-hand drive. If the control module was not previously programmed no data can be read off.

Read off the driver position. Note the value. If the programming is not correct, program in the correct version.

Any further programming to be carried out?

Yes - Programming the Engine Type

No - Information