General Information About Programming

General Information About Programming






NOTE: Before replacing a control module all programmed data must be read out first if this is possible. This is so that the new control module can be programmed with the same data. Check all the variable parameters for the new climate control module.

The ECC Control module can be programmed with certain information. The purpose of the programming is to adjust the control module to the car version or when the requests of the driver for certain adjustments to the settings.
For more information about the values Description of ECC Programmed Data

- Set the blower fan speed selector switch to AUTO.

Programming procedure

Select the desired setting from the list box and then press Continue to program the different settings and to receive more information about the different alternatives.

Other procedures:

- Begin the programming procedure. Make one setting at a time. Work from the top of the list box to the bottom
- Read off all programmed alternatives
- Exit without programming.

1 - Programming Driver Position (LHD or RHD)

2 - Reading Off the Programmed Values

3 - This information to be published by O.E. at a later date.