Dashboard

Dashboard

Windshield wipers




Nut M8, 13 mm.

Gutter




5 Torx 20 screws with washers.

The wiper motor mounting and the dashboard screws




2 10 mm nuts for the wiper motor mounting.
Connector
4 10 mm M6 screws for the dashboard.

The left-hand side soundproofing panel




1 Torx 20 screw.

The right-hand side soundproofing panel




The glove compartment must be removed to access the screws, see Panel and SRS passenger airbag module Panel and SRS Passenger Airbag Module.
2 Torx 20 screws behind the edge of the glove compartment.

The dashboard screws in the passenger compartment




4 Torx 20 screws.
Lift the dashboard out of the car.

Air vent housing




2 Torx 20 screws for the air vent housing. The air vent housing is located on the reverse of the dashboard.
Remove the damper control from the air vent housing and pull it out.

Air vent housing and air ducts




(The illustration shows the reverse of the dashboard)
3 Torx 20 screws.

Air vent housing and air ducts




(The illustration shows the reverse of the dashboard)
2 Torx 20 screws.

Combined instrument panel trim




(The illustration shows the reverse of the dashboard)
Cable duct: 2 Torx 20 screws.
Combined instrument panel frame: 8 Torx 20 screws.

Frame center




(The illustration shows the reverse of the dashboard)
13 Torx 20 screws.

Cable harness routing




(The illustration shows the reverse of the dashboard)
2 Torx 20 screws holding the cable duct.
The cable harness is secured with clips. The securing points are marked with arrows.

Cable harness routing




(The illustration shows the reverse of the dashboard)
The cable harness is secured with clips. The securing points are marked with arrows.

Installation

Note! The screws for the dashboard from the engine compartment must be tightened. Tighten to 8 Nm.