Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Intermittent fault




- Ignition off.
Check the power supply cable between transmission control module (TCM) terminal 57A and vehicle speed sensor (VSS) connector terminal 1 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the signal cable between transmission control module (TCM) terminal 39A and vehicle speed sensor (VSS) connector terminal 2 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting breakout box, Transmission control module (TCM) Connecting Breakout Box, Transmission Control Module (TCM).
- To disconnect the transmission control module (TCM), see Replacing the gearbox control module (TCM) .
- For information about signals, see Signal specification, Transmission control module (TCM) Signal Description AW50-42.













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Intermittent fault

-------------------------------------------------