Fuel System - Quick Release Connector
850, S70/V70/C70, S90/V90, S40/V40, S60, S801993-
Section
2
Group
23
No.
0052
Year
00
Month
11
Reference:
This Service Bulletin replaces the previous Service Bulletin 230052 from October 2000, which should be discarded.
Connecting the Quick release connector, updated method
Background
This Service Bulletin describes an updated method for connecting the quick-release connectors in the fuel injection system.
Material
Connecting the quick-release connector, updated method
1
Quick-release connector, fuel system
There are a number of quick-release connectors on the fuel injection system the fuel tank, the fuel filter and the intake manifold. In addition, a quick-release connector can be found on certain cars at the rear edge of the sub-frame.
These quick-release connectors are of differing designs and are taken apart in different ways. For certain quick-release connectors special tools are required.
All quick-release connectors have O-rings as seals
2
Lubricating when connecting quick-release connectors
The quick-release connectors in the marked area (arrow in the illustration) on the fuel line must be lubricated using lubricant p/n 1161580 before connection.
Note!
Engine oil (mineral oil) may also be used. Do not use synthetic engine oil.
3
Checking that connection is secure
Check that the quick-release connector has locked. Try pulling the connector apart by hand firmly using approximately 10-20 lb of force.
Ensure that there is some ploy in the connector. Press the connector together and pull the connector apart.
The illustration displays an example of the connection.