Adding/Erasing Keys

Adding/Erasing keys

Information

Add key
This function is used when the customer has ordered new keys. The key code for the extra key must be programmed into the control module before the key can be used to start the car. The control module memory has room for six key codes.

Erase key
This function is used when the customer wants to exclude one or more keys from starting the car. These may be lost or stolen keys which could be traced back to the car.
All programmed keys are erased from the control module memory. The remaining keys are then reprogrammed into the control module memory again. It is important that the customer takes all the keys to the workshop. The control module memory has room for six key codes.

Do you wish to continue to add or erase key?

Yes - Ordering software/key

No - DONE

-------------------------------------------------

Ordering software/key

Note! A key and software must be ordered before a key can be added. Only software must be ordered before a key can be erased.

Order key and/or appropriate software. Programming and Relearning


Continue - Programming key in control module

-------------------------------------------------

Programming key in control module

Note! Programming/erasing can be carried out when the key and/or software has been delivered.

Program/erase the key in the control module for S/V 70 according to 9438430.
Program/erase the key in the control module for C 70 according to 9438432.
If a new key has been added the function should be checked.
Check, in VIDA, that no diagnostic trouble codes have been stored during the process.


Continue - DONE

-------------------------------------------------