Checking The Unlit SRS Warning Lamp

Checking the unlit SRS warning lamp

Checking bulbs




- Test with a new bulb as described in Replacing bulb Removal and Replacement.
- Ignition on.

Does the lamp come on for about 3 seconds when the ignition is turned on?

Yes - Verification

No - Checking the combined instrument

-------------------------------------------------

Checking the combined instrument
The trouble-shooting indicates a line break or a short circuit to ground in the combined instrument; check the combined instrument.


Continue - DONE

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall components, reconnect connectors etc.
- Ignition on.

Does the SRS indicator lamp light up as soon as the ignition is switched on?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
The fault should be diagnosed and remedied. Since this is not the case the fault-tracing process has failed.
Complete the fault-tracing for those fault or try again.

Do you want to terminate fault-tracing at this time?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking bulbs

-------------------------------------------------