C70 1999-2002 S70/V70 1999-2000 V70XC 1999-2000 5-CYL Turbo
Electronic Throttle Module (ETM) replacement 5-cyl Turbo C70 1999-2002 S70/V70 1999-2000 V70XC 1999-2000Detach the battery cable from the negative battery terminal. Remove the dipstick guide tube.
Removing the electronic throttle module (ETM)
Loosen the hose clamp of the charge air pipe on the electronic throttle module (ETM). Remove the charge air pipe from the electronic throttle module (ETM).
Remove:
- the intake manifold between the front and air filter housing.
- the four bolts holding the fan cowling cover in place.
Move the cover aside slightly, pull up on the relay holder and unplug the fan connectors.
Remove:
- the charge air hose from the intercooler
- hoses and electrical cables from their retainers
- the two electric cooling fan relays from the fan cowling by bending the relays in toward the engine compartment and pulling up.
Open the cable ties of the electrical cables.
Remove:
- the connectors with retainers on both sides of the fan cowling
- the EVAP valve from the fan cowling
- the fan with cowling
Caution!
Do not cut the electrical cable to the electronic throttle module (ETM). It may be necessary to return the electronic throttle module (ETM) assembly.
If the electric cable of the electronic throttle module (ETM) is behind the starter motor bracket:
Slacken the two nuts. Remove the bolt.
Remove any cable ties and unplug the electronic throttle module (ETM) connector. Pull the electrical cable for the electronic throttle module (ETM) forward from in back of the starter motor bracket.
Remove the 4 electronic throttle module (ETM) screws.
Installing the electronic throttle module (ETM)
Install:
- the new electronic throttle module (ETM) with new gasket
- the 4 bolts until they make contact.
Route the electrical cable from the electronic throttle module (ETM) behind the starter motor bracket.
Fit the bolt in the engine block. Tighten the two nuts and the bolt. Plug in the connector and install the cable tie.
Note!
If the cable was not routed behind the starter motor bracket, fasten the cable along the cable duct using two strip clamps.
Raise the car. Remove the cover from below the engine. Tighten the 4 electronic throttle module (ETM) bolts. Tightening torque 10 Nm. Install the cover below the engine. Lower the car.
Install:
- the fan cowling with its 4 bolts
- the connector retainer before the lower bolt on the fan cowling's (car's) left side is inserted. Tighten the lower bolts. Insert the 2 upper bolts.
- the fan connectors
- the electric cooling fan relay in the holder
- the EVAP valve to the fan cowling
- the connector with retainer on the right side of the fan cowling
- cable ties around electrical cables
- hoses and electrical cables in their retainers/clips
- the charge air hose to the intercooler
- the relay holder and tighten the upper bolts.
Installing the charge air pipe
Install the charge air pipe to the electronic throttle module (ETM). Tighten the hose clamp of the charge air pipe on the electronic throttle module (ETM).
Install:
- dipstick guide tube
- the intake manifold between the front and air filter housing.
Turn the ignition key to position 2. Connect the battery cable to the negative battery terminal.
Ordering and downloading software
Note!
After ETM reload the ECM must be upgraded.
Order and download software for ETM reload and ECM gasoline upgrade.
Finishing work
Check that no diagnostic trouble codes were stored in the control module during repair work. Test drive the car and check the functionality of the engine.