Removal and Replacement

Oil/oil filter, replacing.

Special tools:
999 5679 Oil filter spanner 999 5679 Oil Filter Spanner

Oil/oil filter, replacing

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Drain the engine oil.




Lift up the car and get an oil container.

Position the container under the engine oil trough.

Remove the oil plug.
Drain the engine oil.
It is easier to drain the oil if the engine is at operating temperature.

Warning! Hot oil can scald. Avoid skin contact with engine oil. Applies in particular to contaminated engine oil. Immediately wash hands and any skin that has been in contact with oil. Use a suitable cleaning agent and warm water. Wear protective gloves when working with engine oil.

Remove the oil filter housing





Install:
- the oil plug. Tighten to 38 Nm . Always use a new sealing washer.
Position the container under the oil filter.
Remove the oil filter housing.
Use tool: 999 5679 Oil filter spanner 999 5679 Oil Filter Spanner

Replace the oil filter insert





Remove:
- the filter insert from the housing
- the O-ring that seals between the housing and the oil trough.
Allow the filter insert to drain and then discard it in an approved place.

Install the new filter




- Clean the housing.
- Install a new filter insert.
- Install a new O-ring.
- Lubricate the O-ring.
- Screw the filter housing into place.
Tighten with 25 Nm .

Fill engine oil
Top up oil.

Checking performed work
Start the engine and check:
Start the engine and check for oil leakage.
Stop the engine and give the oil time to run down into the oil trough.
Then check the oil level.
Top up if needed, but do not overfill.
Wipe the engine compartment clean.
Ensure that the steering wheel and gear selector lever are clean.