Vehicle Damage Warnings

CONTROL MODULES:

Connecting/Disconnecting Control Modules:

Connecting/Disconnecting:

Always switch off the ignition before connecting or disconnecting a connector or the test box to a control module.

Temperature:

Temperature:

The control module must not be heated to above 80°C. Remove control module when stoving for example.

Arc Welding:
Disconnect connector from control modules when arc welding.
Remove control module before carrying out any arc welding work close to it.

Replacing:
Do not replace a control module without checking its wiring and components. The new component may be damaged in the same way as the old one.

RADIO:





Make a note of the radio code before disconnecting the battery leads and the car is without voltage supply. Re-enter the code when the work has been completed.