Convertible Top Deck Lid Latch Actuator: Service and Repair

REMOVING THE MOTOR FOR THE COVER PLATE LOCK






Set the convertible top to the position illustrated.
Ignition off.
Make a note of the anti-theft radio code.
Disconnect the battery negative lead.






Remove the 12 screws from the bracket for the motors.
Fold the motor bracket forward.

Note: The bracket for the motors may be secured with butyl tape.

Heat up the metal with a hot air gun.






Remove the 3 nuts for the motor.

Note: Counterhold so that the rubber mounting for the motor is not damaged.

Replace the motor.

Note: Ensure that the drive wires do not move while replacing the motor.

Installing the motor for the cover plate lock

Note: Do not forget the spacer washer. If the washer is not installed, there will be no function.






If the drive wires have moved, adjust so that the measurement A = 45 mm from the edge.

Note: This dimension must be identical on both sides. The lock must be open.

Note: Ensure that the flanges on the wire align in the socket for the motor.

Install in reverse order.
Operate the convertible top manually. See Emergency operation. Service and Repair
Check whether the locks click at the same time when opening and locking the left and right-hand sides.
Ensure that locks are positioned in the same way. If not, rotate one of the locks and try again.