Primer

Primer

Priming untreated panel surfaces




An etching primer should be used as a primer.

Note! Etching primer should be applied to bare panel surfaces. The primer should be sprayed as one coat.

Allow the primer coat to air dry (approximately 20-30 minutes, 20°C (68°F)). Spray filler should not be directly applied to etching primer.

Adjust fill smaller unevenness




Fill any minor pitting (if visible after priming) with fine filler.
Apply the filler in thin layers a maximum of 3 times per hour.
Allow the filler to dry and sand with P 320 sanding paper.
Apply primer.

Note! Polythene filler cannot be applied to etching primer.

Wet sand




Wet sand the primed surface with P 600 sandpaper.