Filler

Filler

General on Filler
Filler gives a solid base, anti-corrosion protection and finish.
Filler of the "non-sanding" material (where the cover coat is sprayed "wet on wet" on the filler without sanding) can be used on well primed areas for a good base and faster paint work repairs. For specific paint data see.

Cleaning
Clean the surface thoroughly before applying filler.

Alt 1: Filler




Spray on the filler.

Sand the filler to matt




Wet sand with P 800 sandpaper. Avoid sanding through.

Wash the surface
Wash the surface thoroughly with cleaning agent.

Blow dry




Blow dry with compressed air and dry off the surface.
Use a Tac-rag (adhesive rag to trap loose particles).

Alt 2: Painting with "nonsanding-paint"




Spray on the "nonsanding-paint".
At least 30-40 micron.

Air
Air for 15-20 minutes at room temperature (20°C (68°F))

Filler wet on wet

Note! Sanding is not required for "nonsanding paint" but if not painted over within 24 hours the paint must be sanded for maximum adhesion to be achieved.

Smooth any unevenness (applies to alternatives 1 and 2)




Smooth any unevenness before beginning painting.
Wet sand any faults and unevenness with P 800 sandpaper.
in those cases where this is not sufficient fill and touch up according to earlier instructions.

Note! "Nonsanding paint" must dry before it can be worked on.

Drying time/surface temperature
20 hours/20°C (68°F)
60 minutes/60°C (140°F)