Checking The Locking Signal From The Door Lock Switch

Checking The Locking Signal From The Door Lock Switch







- Ignition off
- Connect the breakout box
- Connect an ohmmeter between terminals #A16(A16) and #A1(A1).

Turn the key in the driver's door to the locking position.
The value must be infinite when the lock is unaffected and 0 [ohm] when the key is turned to the locking position.

Other information
- To connect the breakout box, Reading and Clearing Diagnostic Trouble Codes

Is the value OK?

Yes - Checking Unlocking Signal From Door Lock Switch

No -