Checking Door Switch In Right Rear Door

Checking Door Switch In Right Rear Door







- Expose the right rear door lock unit.
- Disconnect the black connector from the lock unit.

Connect an ohmmeter between VGLA control module connector #B7 and ground.

If the ohmmeter reads infinite resistance, the door switch in the lock unit is faulty.
If the ohmmeter reads approximately 0 [ohm] check the cable between VGLA control module #B7 and the lock unit black connector terminal 1 for a short-circuit to ground, Checking Wiring and Terminals - Permanent Faults

After performing this procedure Verification