Checking Fuse, Cables

Checking Fuse, Cables







- Ignition off.

Check that fuse 6 is intact. If the fuse is blown, check the circuit after the fuse for a short-circuit to ground according to Checking wiring and terminals - Permanent faults.

Check the cable between control module #B18 and alarm horn relay terminal 4 for an open-circuit according to Checking wiring and terminals - Permanent faults, and for a short-circuit to supply voltage according to Checking wiring and terminals - Permanent faults.

Check cable between alarm horn relay terminal 3 and alarm horn terminal 1 for an open-circuit according to Checking wiring and terminals - Permanent faults.

Check cable between alarm horn terminal 2 and ground for an open-circuit according to Checking wiring and terminals - Permanent faults, and for a short-circuit to supply voltage according to Checking wiring and terminals - Permanent faults.

Remedy as necessary.

Checking Wiring and Terminals - Permanent Faults

Was a fault detected?

Yes - Verification

No - Replacing Component