Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Intermittent fault








- Ignition off.
- Disconnect the control module connector.




Check the cable between control module connector #45 and collision sensor connector #1.
Take a reading for an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Also check the ground lead between control module connector #20 and collision sensor connector #2.
Check for a short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information
- To access the control module connector, see SRS control module Service and Repair.
- To access the collision sensor connector, see Side impact sensors Service and Repair.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Intermittent fault

-------------------------------------------------