Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Checking the connector








- Ignition off.
- Disconnect the seat belt buckle connector.
- Check the seat belt buckle connector for intermittent contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
- Remedy as necessary.
- Ignition on.
Check that there is supply voltage at connector #1.
Remedy as necessary.

Other information
- To access / replace the seat belt buckle connector, see Seat belt Service and Repair.













Continue - Checking wiring

-------------------------------------------------

Checking wiring
Check both seat belt buckle connector #1 and #2 for an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.









Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the connector

-------------------------------------------------