Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Intermittent fault








- Ignition off.
- Disconnect seat connector.
- Check connector for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
- Ignition on.
Connect an oscilloscope between left seat connector #1 and ground.
The oscilloscope should display a spiked pulse with an interval of 500 ms and an offset of approximately 2 V.
Now repeat the reading between SIPS bag connector #2 and ground. The oscilloscope should now read approximately 2 V
Remedy as necessary.









Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT FOUND - FAULT-TRACING FAILED

Attempt New Test - Intermittent fault

-------------------------------------------------