Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking components and wiring








- disconnect the driver's airbag connector.
- Ignition on.
Connect an oscilloscope between driver's airbag #1 and #3. Test for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
The oscilloscope should now display a spiked pulse with an interval of approximately 500 ms.
Also take a reading between ground and airbag #3. The oscilloscope should not give any reading.
The cable harness must be replaced if there is a fault in the wiring. No repairs may be made to the cable harness.
Remedy as necessary.

Note! Diagnostic trouble code (DTC) SRS-212 is stored after this reading has been taken. Ignore the diagnostic trouble code (DTC), which is stored due to this operation.

Other information:
- To access the driver's airbag, see Airbag steering wheel module, steering wheel and contact reel Airbag Steering Wheel Module, Steering Wheel and Contact Reel Replacement.









Select Continue when the fault has been remedied.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

Attempt New Test - Checking components and wiring

-------------------------------------------------