Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the connectors and cables








- Ignition off.
- Disconnect the control module.
For S1: Take a reading between the control module 6 and 5 respectively between 2 and 5 for an intermittent short-circuit to supply voltage Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
For S2: Take a reading between control module 6 and 21 and between 2 and 21 for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information:
- To disconnect the control module, see Replacing the Roll-over Protection System (ROPS) module Service and Repair.









Select "Continue" when the fault has been repaired.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

Attempt New Test - Checking the connectors and cables

-------------------------------------------------