Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Checking the wiring








- Ignition off.
- Disconnect the control module connector.
Connect an ohmmeter between 5 and 21. Test for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the control module connector for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
The ohmmeter should read infinite resistance.
Remedy as necessary.

Other information:
- To disconnect / replace the control module, see Replacing the Roll-over Protection System (ROPS) module Service and Repair.









Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the wiring

FAULT-TRACING FAILED - DONE

-------------------------------------------------