Entry Position Not Stored
Entry position not stored
Erase DTCs
- Ignition on.
Erase diagnostic trouble code (DTC).
Continue - Read diagnostic trouble code (DTC)
-------------------------------------------------
Read diagnostic trouble code (DTC)
- Ignition on.
Read diagnostic trouble code (DTC)
Does the diagnostic trouble code (DTC) recur?
Yes - Replacing component
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
The likely cause of the diagnostic trouble code (DTC) is probably because the entry position has not been programmed.
Continue - Verification
-------------------------------------------------
Replacing component
The likely cause of the diagnostic trouble code (DTC) is an internal fault in the control module.
Try a new control module according to Control module, replace Control Module.
Select Continue when the fault has been remedied.
Continue - Verification
-------------------------------------------------
Verification
Verification
Note! After carrying out the repair, check that the fault has been remedied as follows.
- Ignition on.
Erase diagnostic trouble code (DTC).
Continue - Verification, continued
------------------------
Verification, continued
- Ignition on.
- Move the seat to entry position.
Read off diagnostic trouble codes (DTCs).
Does the diagnostic trouble code (DTC) recur?
Yes - VERIFICATION FAILED
No - VERIFIED
------------------------
VERIFICATION FAILED - Fault-tracing information
VERIFIED - FAULT FOUND
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit fault-tracing
No - Attempt New Test
------------------------
Attempt New Test - Erase DTCs
-------------------------------------------------