Not Programmed

Not programmed

IMM-132 Key codes

Checking initiation




- Ignition on.
Check if the immobilizer is initiated by reading the IMMO STATUS parameter.





Is the NORMAL parameter displayed?

Yes - Programming keys

No - Initiation

-------------------------------------------------

Programming keys




- Program the car keys according to Add/delete key Add/Delete Key.
- Ignition on.




- Erase diagnostic trouble codes (DTCs).

Continue - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Initiation
Initiate immobilizer control module according to Initiate the immobilizer control module. Initiate the Immobilizer Control Module.

Continue - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Reading off diagnostic trouble codes (DTCs)




- Ignition off.
- Ignition on.
Read DTCs.





Has diagnostic trouble code (DTC) IMM-132 been stored again?

Yes - Replacing the control module

No - Fault-tracing information

-------------------------------------------------

Replacing the control module
Try a new control module according to Replacing immobilizer control module Replacing Immobilizer Control Module.
Initiate the new control module according to Initiate the immobilizer control module. Initiate the Immobilizer Control Module.

Continue - Verification

-------------------------------------------------

Fault-tracing information
The keys are programmed into the immobilizer control module memory.

Continue - Verification

-------------------------------------------------

Verification




Verification





Hint: After finishing the repair check that the repair is successful and that the fault is corrected as follows.

Does the car start with all keys ?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Diagnostic trouble code (DTC) information

-------------------------------------------------

Diagnostic trouble code (DTC) information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking initiation

-------------------------------------------------