Faulty Signal. Permanent Fault

Faulty signal. Permanent fault

Replacing and programming the engine control module (ECM)




The engine control module (ECM) has registered an incorrect configuration.

Caution! A new engine control module (ECM) is delivered without software. The engine control module (ECM) must be programmed before it will function after replacement.

For information about programming and replacing the engine control module (ECM), see Engine control module (ECM), replacing Service and Repair.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Replacing and programming the engine control module (ECM)

-------------------------------------------------