Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition




If Engine control module (ECM) registers that the signal from the clutch pedal position sensor is:
- Lower than 9.0% for longer time than 0.16 seconds, then ECM-9300, Too low signal, is stored.
- Higher than 79.7% for longer time than 0.16 seconds, then ECM-9300, Too high signal, is stored.
- Between 72.3 % and V 79.7 % for longer time than 0.16 seconds, then ECM-9300, Faulty signal, is stored.
For upgraded software, released during year 2006 or later, the fault type Faulty signal is no longer necessary and therefore has been removed. With regards to detection times for the other fault types, these are increased from 0.16 to 5 seconds.

For more information about the electronic throttle system and related components such as the electronic throttle module, accelerator pedal position sensor, brake light switch, clutch pedal position sensor, and brake pedal position sensor: Design Design

Substitute value

Cruise control off.
Cruise control off during entire operating cycle in which fault was detected. If the fault is no longer present, the function is available the next time the car is started.

Possible source

Signal too high
- short-circuit to supply voltage in the signal cable
- Open circuit on signal cable.
- Open-circuit in the ground lead.
- Damaged clutch pedal position sensor.

Signal too low
- short-circuit to ground in the signal cable
- defective clutch pedal position sensor

Faulty signal
- defective clutch pedal position sensor
- open-circuit in signal cable
- incorrectly installed clutch pedal position sensor

Fault symptom[s]
- ETS warning lamp lit
- cruise control does not function at all