Faulty Signal. Permanent Fault

Faulty signal. Permanent fault

Replacing throttle unit and programming




The throttle unit has registered an internal fault. Registration has occurred in the engine control module (ECM).

Caution! A new throttle unit is delivered without software. For the throttle unit to function after replacement, the throttle unit must be programmed.

For information about programming and replacing the throttle unit, see Replacing the throttle body (electronic throttle module) Removal and Replacement.

Continue - Fault-tracing information
FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Replacing throttle unit and programming

-------------------------------------------------