Signal Too High. Permanent Fault

Signal too high. Permanent fault

Checking cables
Check reset valve camshaft resistance between #1 and #2, resistance should be approximately 3.7 ohm.
Check the signal cable between engine control module (ECM) #A13 and camshaft reset valve #2 for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box.
- With the ignition on and camshaft reset valve connector disconnected the voltage on connector #1 should be approximately Ubat and connector #2 be a pulse modulated signal with top voltage at approximately Ubat and with a frequency of approximately 250 Hz.
- For information about signals, see Signal specification Signal Specifications.














Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off.
- Reinstall connectors, components etc.
- Ignition on.
- Start the engine.
- Increase engine speed (RPM) on the engine and read off the camshaft timing alterations.









Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking cables

-------------------------------------------------