Signal Too High. Intermittent Fault
Signal too high. Intermittent fault
Checking components and wiring
Check the cable between the engine control module (ECM) terminal #B41 (#B51) and combined instrument panel terminal #B1 (terminal #31). Check for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.
Other information
- To connect the engine control module (ECM) breakout box, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box
- To connect the combined instrument panel breakout box, see Driver information module (DIM), replacing Driver Information Module (DIM), Replacing
- For information about signals see Signal specification Signal Specifications.
Continue - Fault-tracing information
DONE
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - FAULT FOUND
------------------------
Attempt New Test - Checking components and wiring
FAULT FOUND - DONE
-------------------------------------------------