Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking cables
Check signal cable between control module #A47 (#A47) and camshaft position (CMP) sensor connector #2 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults and an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults. Check the ground lead between control module #A65 (#A65) and camshaft position (CMP) sensor connector #3 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information
- Connecting the breakout box/accessing the control module, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box.
- Location of components see Location of components, only B52X4 T Locations.
- For information about signals, see Signal specification Signal Specifications.










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking cables

FAULT FOUND - DONE

-------------------------------------------------