Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking cables

Caution! Do not apply rust solvent spray or grease to the heated oxygen sensor (HO2S) connector.

Check the signal cable (+) between heated oxygen sensor (HO2S) #4 and control module #A61 (#B1) and the signal cable (-) between heated oxygen sensor (HO2S) #3 and control module #A62 (#B2) for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information
- Connecting the breakout box/accessing the control module, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box.
- To access/replace the heated oxygen sensor (HO2S), see Replacing lambda probes, B5234T9, B5244T7 Replacing Lambda Probes.
- For information about signals, see Signal specification Signal Specifications.














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking cables

FAULT FOUND - DONE

-------------------------------------------------