Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Checking cables

Caution! Do not apply rust solvent spray or grease to the heated oxygen sensor (HO2S) connector.

Check signal cable (+) between heated oxygen sensor (HO2S) #4 and control module #A61 (#B1) and the signal cable (-) between heated oxygen sensor (HO2S) #3 and control module #A62 (#B2) for an intermittent short-circuit to ground according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.

Other information
- Connecting the breakout box/accessing the control module, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box.
- To access/replace the heated oxygen sensor (HO2S), see Replacing lambda probes, B5234T9, B5244T7 Replacing Lambda Probes.
- For information about signals, see Signal specification Signal Specifications.














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking cables

FAULT FOUND - DONE

-------------------------------------------------