Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Checking cables and connectors
Check injector connector for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults and loose connections according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
Check cable between injector terminal 2 and control module:
- #A16 (#A16) (ECM 2310)
- #A34 (#A34) (ECM 2320)
- #A15 (#A15) (ECM 2330)
- #A33 (#A33) (ECM 2340)
- #A14 (#A14) (ECM 2350)
and power supply between system relay terminal 3 and injector terminal 1 for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information
- Connecting the breakout box/accessing the control module, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box.
- To access/replace the injector, see Service and Repair.
- For information about signals, see Signal specification Signal Specifications.














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking cables and connectors

FAULT FOUND - DONE

-------------------------------------------------