Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition
If there is no signal from the micro-switch (tensioner rib up), the motor for the tensioner rib will continue to run against a mechanical stop. Overload is registered.
Diagnostic trouble code (DTC) CCU-320 is stored.

Possible source
- Open-circuit in the cable from the micro-switch
- Short-circuit to supply voltage in the cable from the micro-switch
- The micro-switch is not in position
- The potentiometer locking arms do not reach the catch position. The striker plate for the tensioner rib locks in the latch.

Fault symptom[s]
- Convertible top control does not function.