Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Checking the connector

Note! The diagnostic trouble code (DTC) erases itself. This means that it is erased if the vehicle speed signal returns.

Note! The fault may also be in other speed dependent systems.




- Ignition off
- Check the control module connector for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Connect an ohmmeter between control module A22 and combined instrument panel A7. Check for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.













Other information:
- To connect the breakout box, see Connecting the convertible control unit breakout box Connecting the Breakout Box
- To access and replace the control module see Replacing the control module Service and Repair.

Select Continue when the fault has been remedied

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

Attempt New Test - Checking the connector

-------------------------------------------------