Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Checking the wiring




- Check control module connector D for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
- Ignition on.
Connect a voltmeter between D1 and ground and between D2 and ground. Check for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information:
- To access and replace the control module see Replacing the control module Service and Repair
- To connect the breakout box, see Connecting the convertible control unit breakout box Connecting the Breakout Box.









Was a short-circuit found?

Yes - Checking the engine

No - Checking the control module

-------------------------------------------------

Checking the engine




- Ignition on
- Check the relevant motor connector for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Connect a voltmeter between 1 and ground and between 2 and ground. Check for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Replace the motor if a short-circuit is found.
If no short-circuit is found, the fault is in the cable between the control module and the motor connectors.
Remedy as necessary.

Other information:
- To access and replace the motor for the front lock, see Replacing motors Service and Repair
- To access or replace the motor for the cover plate lock, see Replacing motors Service and Repair.









Select Continue when the fault has been remedied.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Checking the control module
Fault-tracing indicates that the control module has previously registered an intermittent fault but that the fault is no longer present.
Test operate the convertible system according to Test operating the convertible system Test Operating the Convertible System.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

Attempt New Test - Checking the wiring

-------------------------------------------------