Invalid Position. Permanent Fault

Invalid position. Permanent fault

Checking the function of the convertible top
If only diagnostic trouble code (DTC) CCU-120 is stored, try operating the convertible top to one of the limit positions with the rocker switch.
If this does not operate the convertible top, click on the Volvo Scan Tool (ST) symbol to move the convertible top to one of the limit positions.
If the convertible top cannot be moved via the Volvo Scan Tool (ST) there may be a mechanical fault.
Remedy as necessary.

Other information
- For the comment sheet, see Diagnostic list for convertible tops Diagnostic List For Convertible Tops
- For other values, see Opening and closing the convertible top Opening and Closing the Convertible Top.





Select Continue when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off
- Connect the connectors, install the components, etc.
- Ignition on
- Apply parking brake
- Close the luggage compartment lid
- Speed < 4km/h.
Operate the control switch to move the convertible top.
Move the convertible top to its end positions.

Does the convertible top work?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the function of the convertible top

-------------------------------------------------