Fog/Driving Lamp Bulb: Service and Repair

For replacement of entire tail lamp assembly, Service and Repair

AF1 Position of Bulbs:

From the top the bulbs have the following functions:
1 = Turn signal lamps.
2 = Stop (brake) lamp.
3 = Tail lamp.
4 = Back-up (reversing) lamp.
5 = Tail lamp, and on the left-hand side a fog tail lamp (LHD cars).

For type of bulb, Specifications

AF2 Replacing Upper Tail Lamp Bulbs:





Replace the tail lamp bulbs from inside the passenger compartment.
- Turn ignition off.
- Open cover with a flat screwdriver.
- Remove loudspeaker.
- Press down catches and pull out bulb holder.
- Replace the faulty bulb.
- Assemble in reverse order.

NOTE: Ensure that the catches engage properly.

- Test all bulbs.

AF3 Replacing Lower Tail Lamp Bulbs:





- Turn ignition off.
- Remove rear, outer floor hatch.
- Turn the retaining clip a 1/4 turn on the cover in front of the tail lamp. Remove the cover by pressing it down a little.
- Press in the two catches and lift out the bulb holder.
- Replace the faulty bulb.
- Assemble in reverse order.

NOTE: Ensure that the catches engage properly

- Test all bulbs.