Faulty Signal

ECM-930A CLUTCH PEDAL SENSOR
FAULTY SIGNAL

Engine control module (ECM)
Reading off the status of the diagnostic trouble code (DTC):



Note! When reading off the DTC status, other stored diagnostic trouble codes (DTCs) and their status will also be listed.

- Start the engine. Let it idle for at least 15 seconds.
- Read off the diagnostic trouble code (DTC) status. Check the status of the relevant diagnostic trouble code (DTC).

Was the status of the relevant diagnostic trouble code (DTC) permanent?
Yes - Skip to "Checking the Function of the Clutch Pedal Sensor"
No - Continue below.


Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
--Testing Complete--


Checking the Function of the Clutch Pedal Sensor



Check the installation and function of the clutch pedal sensor.

Remedy as necessary.


Fault-tracing information
Fault-tracing is not followed by verification for this fault.