Contact Reel Replacement Procedure

CDA15. Removal of contact reel/SRS

Remove:
the steering column cover and selector.
3 screws on the contact reel/SRS
the connector from the contact reel.

Assembly






CDA16. Resetting the contact reel to zero
If the locking screw is not in the lock position as shown in the figure, reset the contact reel to zero. For resetting to zero Clockspring Assembly / Spiral Cable

NOTE: The new contact reel is reset to zero when locking screws are positioned in the lock position. Resetting to zero ensures that all electrical functions on the steering column operate and damage to the contact reel does not occur.



CDA17. Installation of contact reel/SRS






Install:
The contact reel/SRS
3 screws on the contact reel/SRS. Tighten the screws on the contact reel to 2.5 Nm (1.9 ft-lb). Make sure that no wires are trapped
The connector
apply to the contact rail to ensure a good contact.