Faulty Signal - Permanent Fault

ECM-E000 CONTROL MODULE, INTERNAL FAULT
FAULTY SIGNAL - PERMANENT FAULT

Other diagnostic trouble codes

Note! The combined instrument performs a general check of the communications net and has a number of trouble codes informing of any fault. When there is communication trouble, the problem could be somewhere else in the communication net.

If there are any trouble codes stored in the combined instrument, you should trouble-shoot according to these codes.

Is there a trouble codes stored in the combined instrument?
Yes - Tesing Complete.
No - Continue below.


Replacing engine control module (ECM) and programming



Engine control module (ECM) has registered an internal fault.

CAUTION!
A new engine control module (ECM) is delivered without software. For the engine control module (ECM) to function after replacement the engine control module (ECM) must be programmed.

For information about programming and replacing the engine control module (ECM), Engine Control Module (ECM), Replacing


Fault-tracing information
Fault-tracing is not followed by verificatiohn for this fault.