Transmission Output Speed Sensor, Replacing

Transmission output speed sensor, replacing

Preparations
Switch off the ignition.

Remove the air cleaner (ACL) housing
See Brake pipe master cylinder / ABS unit, replacing Brake Pipe Master Cylinder / ABS Unit, Replacing

Separate the vehicle speed sensor (VSS) connector. Remove the sensor




Remove the nut for the cable duct / bracket. Unhook the components.
Clean thoroughly around transmission output speed sensor. Remove the sensor.

Lubricate the O ring for the new vehicle speed sensor (VSS). Install the sensor




Install the sensor. Tighten to 5.5 Nm .

Install:
- the bracket and cable duct. Tighten to 5.5 Nm
- the connector.

Install the air cleaner (ACL) housing
See Brake pipe master cylinder / ABS unit, replacing Brake Pipe Master Cylinder / ABS Unit, Replacing

Checking diagnostic trouble codes (DTCs)
Check and erase any diagnostic trouble codes (DTCs).