Checking The Illuminating Light In The Passenger Air Bag Cut-Off Switch.

Checking the illuminating light in the passenger air bag cut-off switch.

Checking the wiring




- Ignition on.
- Check that there is voltage on connector #1.
Do the necessary corrective action.

Select Continue when fault has been rectified.

Continue - Checking the wiring, continued

-------------------------------------------------

Checking the wiring, continued




- Ignition off.
If no faults were found in the wires, test by replacing the switch if the customer thinks this necessary.

Select Continue when fault has been rectified.

Continue - Verification

-------------------------------------------------

Verification




- Ignition on.

Hint: After the repair it is necessary to check that the fault has been rectified.

Check that the text on the passenger air bag cut-off switch is lit up from inside the switch.

Does the lighting work?

Yes - FAULT FOUND

No - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------