No Signal. Intermittent Fault

No signal. Intermittent fault

Intermittent fault








- Ignition off.
- Disconnect the control unit connector.




Check the wire between control unit connector #21 and impact sensor connector #3.
Check for an intermittent short circuit to ground, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check also the ground wire between control unit connector #46 and impact sensor connector #1.
Check for open circuits, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Do the necessary corrective action.

Additional information
- To access the control unit connector, see Service and Repair.
- To access the side impact connector, see Side impact sensors Service and Repair.

Select Continue when fault has been rectified.

Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Intermittent fault

-------------------------------------------------