Signal Faulty. Permanent Fault

Signal faulty. Permanent fault

Checking connector and wire




- Ignition off.




Check the seat-belt buckle connector for contact resistance and oxidation, as described in Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault
If no fault was found, test using a new seat-belt buckle.

Additional information
- To access/replace seat-belt buckle, see Service and Repair.

Select Continue when fault has been rectified.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the status of the diagnostic trouble code (DTC) has changed to intermittent.





Does the status change?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Trouble-shooting information

VERIFIED - FAULT FOUND

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking connector and wire

-------------------------------------------------