Signal Faulty. Intermittent Fault

Signal faulty. Intermittent fault

Checking the connector








- Ignition off.
- Disconnect seat-belt buckle connector.
- Check the seat-belt buckle connector for intermittent contact resistance and oxidation, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults
- Do the necessary corrective action.
- Ignition on.
Check that there is supply voltage on connector #1.
Do the necessary corrective action.

Additional information
- To access/replace seat-belt buckle connector, see Service and Repair.













Select Continue when fault has been rectified.

Continue - Checking the wiring

-------------------------------------------------

Checking the wiring
Check seat-belt buckle connector #1 and #2 for an intermittent short circuit to ground, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Do the necessary corrective action.









Select Continue when fault has been rectified.

Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the connector

-------------------------------------------------