No Signal. Intermittent Fault

No signal. Intermittent fault

Intermittent fault












- Make a note of any radio code.
- Ignition off.
- Disconnect the battery negative lead.
- Disconnect connector from passenger air bag.
- Disconnect the control unit.
- Check the connectors for contact resistance and oxidation, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check in particular for damage etc.

Warning! Never use an ohmmeter or any other charged measuring instrument on a disconnected, undeployed air bag module. There is a risk that the air bag could be deployed!

Connect an ohmmeter between passenger air bag #1 and #2 and check for an intermittent open circuit, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Do the necessary corrective action.

Additional information:
- To access the control unit, see Service and Repair.
- To access the passenger air bag, see Removal and Replacement.













Select Continue when the fault has been rectified.

Continue - Trouble-shooting information
DONE

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

Attempt New Test - Intermittent fault

-------------------------------------------------