Removal

1. Remove wheel.





2. Undo:
a. Brake pipe from mounting clips on the rear axle.
b. Three-way junction from the trailing arm.

NOTE: Left side only.

3. Remove brake caliper screws. Hang caliper by a wire.





4. Release parking brake shoe adjuster.
5. Remove:
a. Guide pin
b. Brake disc
c. Cover
d. Hub nut
e. Hub.





6. Remove ABS-system sensor.

NOTE: Do not disconnect the sensor connector.

7. Remove parking brake shoes.





8. Remove:
a. The brake cable screw in the brake backing plate and remove the bracket for the cable guide sleeve (applies to models with plastic side panels only).
b. The four brake backing plate bolts and the brake shoe retaining springs.
c. Brake backing plate.





9. Remove protective cable cover with fixed plastic guide sleeve on the end piece.
a. Remove cigarette lighter panel (2 screws) and cover under the handbrake lever.

NOTE: On certain models, undo the OBD DLC from the panel.

b. All models remove the storage compartment cover and the tunnel bracket. Disconnect the tunnel bracket connectors. Remove screws (4) and remove the bracket.





10. Undo the parking brake cable. Remove the cable segment circlip. Remove the segment from the axle and cable.





11. Pull out the cable and remove the parking brake segment from the cable. Take care not to damage the protective cable cover.





12. Remove the four bolts holding the axle end piece.
13. Hold in the axle when the bolts are removed. Disconnect the parking brake cable from the axle end piece by twisting the cable cover sleeve up and down a little.
14. Remove the axle.